2. 7. 5 Module Quiz - Single-Area OSPFv2 Configuration (Answers) A network engineer has manually configured the Hello interval to 15 seconds on an interface of a router that is running OSPFv2 By default, how will the Dead interval on the interface be affected?
CCNA 3 Chapter 5 v5. 0 Exam Answers 2015 (100%) A network engineer has manually configured the hello interval to 15 seconds on an interface of a router that is running OSPFv2 By default, how will the dead interval on the interface be affected?
IP OSPF Hello Interval Command on CISCO Router Switch Syntax Router (config-if)#ip ospf hello-interval <seconds> Example In this example, the hello interval is modified for int fa0 0 on R1 Here’s the ospf information for fa0 0 before the change Notice the hello interval set to the default value of 10 R1#conf t R1(config)#int fa0 0 R1(config-router)#do show ip ospf interface fa0 0 FastEthernet0 0 is up, line protocol is up Internet Address 10
2. 7. 1 Packet Tracer - Single-Area OSPFv2 Configuration (Answers) Background You are helping a network engineer test an OSPF set up by building the network in the lab where you work You have interconnected the devices and configured the interfaces and have connectivity within the local LANs Your job is to complete the OSPF configuration according to the requirements left by the engineer
1. 4. 2 Module Quiz – Single-Area OSPFv2 Concepts (Answers) A router is participating in an OSPFv2 domain What will always happen if the dead interval expires before the router receives a hello packet from an adjacent DROTHER OSPF router?